Herbicide

A herbicide is a pesticide used to kill unwanted plants. Selective herbicides kill certain targets while leaving the desired crop relatively unharmed. Some of these act by interfering with the growth of the weed and are often based on plant hormones. Herbicides used to clear waste ground are nonselective and kill every plant with which they come into contact.

History

Prior to the widespread use of chemical herbicides, cultural controls, such as altering soil pH, salinity, or fertility levels, were used to control weeds. The first widely used herbicide was 2,4 dichlorophenoxyacetic acid, often abbreviated 2,4-D. It first saw widespread production and use in the late 1940s. It is easy and inexpensive to manufacture, and kills many broadleaf plants while leaving grasses unaffected. Its low cost has led to continued usage today. Like other acid herbicides, current formulations utilize either an amine salt (usually trimethyl amine) or one of many esters (ester) of the base compound. These are easier to handle than the acid. 2,4-D exhibits relatively poor selectivity, meaning that it causes stress to non-target plants. It is also less effective against some broadleaf weeds, including sedges and many vinous plants. A herbicide is termed selective if it affects only certain types of plants, and nonselective if it inhibits most any type of plant. Other herbicides have been more recently developed to achieve the desired selectivity. The 1970s saw the introduction of atrazine, which has the dubious distinction of being the herbicide of greatest concern for groundwater contamination. Atrazine does not break down readily (within a few weeks) after being applied. Instead it is carried deep into the soil by rainfall causing the aforementioned contamination. Atrazine is said to have high carryover, a very undesirable property for herbicides. Glyphosate, frequently sold under the brand name Roundup, was introduced in the late 1980s for non-selective weed control. It is now a major herbicide in selective weed control in growing crop plants due to the development of crop plants that are resistant to it. The pairing of the herbicide with the resistant seed led to the consolidation of the seed and chemistry industry in the late 1990s. Modern chemical herbicides for agriculture are specifically formulated to decompose within a short period after application. This is desirable as it allows crops which may be affected by the herbicide to be grown on the land in future seasons.

Uses

Herbicides are widely used in management of landscape turf and in agriculture. They are used in total vegetation control (TVC) programs for maintenance of highways and railroads. Relatively smaller quantities are used in forestry, pasture systems, and management of areas set aside as wildlife habitat.

Classification of herbicides

Herbicides can be grouped by chemical family, mode of action, and type of vegetation controlled. By activity:

• Contact herbicides destroy only the plant tissue in contact with the chemical spray. Generally, these are the fastest acting herbicides. They are ineffective on perennial plants, which are able to regrow from roots or tubers.

• Systemic herbicides are foliar-applied and are translocated through the plant. They destroy a greater amount of plant tissue than contact herbicides.

• Soil-borne herbicides are applied to the soil and are taken up by the roots of the target plant.

• Pre-emergent herbicides are applied to the soil and prevent germination or early growth of weed seeds.

Their classification by mechanism of action (MOA) indicates the first enzyme, protein, or biochemical step affected in the plant following application. The main mechanisms of action are:

• ACCase inhibitors are compounds that kill grasses. ACCase is part of the first step of lipid synthesis. Thus, ACCase inhibitors affect cell membrane production in the meristems of the grass plant. The ACCases of grasses are sensitive to these herbicides, whereas the ACCases of dicot plants are not.

• ALS inhibitors: the ALS enzyme is the first step in the synthesis of the amino acids valine, leucine, and isoleucine. These herbicides also affect the cell membrane at the meristem. They affect grasses and dicots alike.

• EPSPs inhibitors: The enzyme EPSPs is used in the synthesis of the amino acids tryptophan, phenylalanine and tyrosine. The effect of this group of compounds is noted on the entire plant. They affect grasses and dicots alike.

• Synthetic auxin inaugurated the era of organic herbicides. They were discovered in the 1940s after a long study of the plant growth regulator auxin. They have several points of action on the cell membrane, and are effective in the control of dicot plants.

• Photosystem II inhibitors reduce electron flow from water to NADPH2+ at the photochemical step in photosynthesis. They bind to the Qb site on the D2 protein, and prevent quinone from binding to this site. Therefore, this group of compounds cause electrons to accumulate on chlorophyll molecules. As a consequence, oxidation reactions in excess of those normally tolerated by the cell occur, and the plant dies.

Application

Most herbicides are applied as water-based sprays using ground equipment. Ground equipment varies in design, but large areas can be sprayed using self-propelled sprayers equipped with a long boom, of 60 to 80 feet (20 to 25 m) with flat fan nozzles spaced about every 20 in (500 mm). Towed, handheld, and even horse-drawn sprayers are also used. Herbicides can also be applied aerially using helicopters or airplanes, and can be applied through irrigation systems (chemigation).

Terminology

• Control is the destruction of unwanted weeds, or the damage of them to the point where they are no longer competitive with the crop
• Suppression is incomplete control still providing some economic benefit, such as reduced competition with the crop
• Crop Safety, for selective herbicides, is the relative absence of damage or stress to the crop. Most selective herbicides cause some visible stress to crop plants.

Some major herbicides in use today

• Glyphosate, a systemic nonselective (it kills any type of plant) herbicide used in no-till burndown and for weed control in crops that are genetically modified to resist its effects. It is an example of an EPSPs inhibitor.
• Paraquat, a nonselective contact herbicide used for no-till burndown and in aerial destruction of marijuana and coca plantings. More acutely toxic to people than any other herbicide in widespread commercial use.
• 2,4-D, a broadleaf herbicide in the phenoxy group used in turf and in no-till field crop production. Now mainly used in a blend with other herbicides that act as synergists. It is an example of synthetic auxin.
• clopyralid, is a broadleaf herbicide in the pyridine group, used mainly in turf, rangeland, and for control of noxious thistles. Notorious for its ability to persist in compost. It is another example of synthetic auxin.
• metoalachlor, a pre-emergent herbicide widely used for control of annual grasses in corn and sorghum; it has largely replaced atrazine for these uses.
• dicamba, a persistent broadleaf herbicide active in the soil, used on turf and field corn. It is another example of synthetic auxin.
• picloram, a pyridine herbicide mainly used to control unwanted trees in pastures and edges of fields. It is another synthetic auxin.
• atrazine, a triazine herbicide used in corn and sorghum for control of broadleaf weeds and grasses. Still used because of its low cost and because it works as a synergist when used with other herbicides, it is a photosystem II inhibitor.

Other herbicides of historical interest

• 2,4,5-Trichlorophenoxyacetic acid (2,4,5-T) was a widely used broadleaf herbicide until being phased out starting in the late 1970s. While 2,4,5-T itself is of only moderate toxicity, the manufacturing process for 2,4,5-T contaminates this chemical with trace amounts of 2,3,7,8-tetrachlorodibenzo-p-dioxin (TCDD). TCDD is extremely toxic to people. With proper temperature control during production of 2,4,5-T, TCDD levels can be held to about .005 ppm. Before the TCDD risk was well understood, early production facilities lacked proper temperature controls. Individual batches tested later were found to have as much as 60 ppm of TCDD.

• 2,4,5-T was withdrawn from use in the USA in 1983, at a time of heightened public sensitivity about chemical hazards in the environment. Public concern about dioxins was high, and production and use of other (non-herbicide) chemicals potentially containing TCDD contamination was also withdrawn. These included pentachlorophenol (a wood preservative) and PCBs (mainly used as stabilizing agents in transformer oil).

Some feel that the 2,4,5-T withdrawal was not based on sound science. 2,4,5-T has since largely been replaced by dicamba and triclopyr.

• Agent Orange was a herbicide blend used by the U.S. military in Viet Nam between January 1965 and April 1970 as a defoliant. It was a mixture of 2,4,5-T, 2,4-D, and picloram. Because of TCDD contamination in the 2,4,5-T component, it has been blamed for serious illnesses in many veterans who were exposed to it. However, research on populations exposed to its dioxin contaminant have been inconsistent and inconclusive. Agent Orange often had much higher levels of TCDD than 2,4,5-T used in the US. The name Agent Orange is derived from the orange color-coded stripe used by the Army on barrels containing the product. It is worth noting that there were other blends of synthetic auxins at the time of the Vietnam War whose containers were recognized by their colors.

See also; Weed control, weed, farming, agriculture, FIFRA- Federal insecticide, fungicide, and rodenticide act (USA) (also covers herbicides despite the title), Organic farming, Organic gardening

See also

• Bioherbicide
• :Category: Herbicides

External links

Manufacturers and distributors

• Dowagro
• Syngenta
• BASF
• Monsanto

Regulatory policy

• EPA

Usage statistics

• USDA

2,4,5-T

• www.gr.nl

Category:Pesticide da:Herbicid de:Herbizid es:Herbicida fr:Herbicide ja:除草剤 nl:Herbicide pl:Herbicyd

View Live Article.
This article is from Wikipedia. All text is available under GNU FDL